
• Tools you need And the Illuminated Door Sill



• You need the remove the cover and screw before to pop the side door cover

• After to removed the door cover. Clean the area before you put the door sill. Measure where the center and place the door sill



• Removed the rubber seal. Check where's the curve and place the wire


• Now we need to check the (-) Neg wire..
• Remove the Cover and screw to check the (-) Neg color wire- It's Solid Brown @ Driver Side



• Open the black loop to find the Solid Brown for (-) Neg Wire.

• I used T Tap for connection


• Here's the Passanger Side. Need to look for (-) Neg Solid Green




• Now need to connect and find were the (+) Pos Wire. I ran the (+) Pos wire on the inside of the carpet and removed the center side cover (Passenger and Driver Side).






• I used Tap Fuse to connect on the Fuse Box (Use #14) for the (+) Pos Wire.

• The Result of the Illuminated Door Sill
• Diver Side


• Passenger Side

