In this thread, I will be showing how I wired my LED footwells. There will be two parts, the first part is the LEDs will turn on with your Parking lights and the second part will also turn on with the Parking light but you have the option to turn it off and on.
Tools/ Materials
Zip Ties
Drill with Small Drill Bit
Mimi Add-A-Fise with ATM 5 amp Fuse
LEDs of your choice
Speaker Wires
T-Taps (Areas where I said add a T-Tap, you can solder the wires)
OEM Material for Part 2
- Honda Ambient Button (08E10-TA0-1M035)
- Honda Crosstour 3 Hole Garnish (77302-TA0-Y01ZA)
- Blank Cover (77755-SVA-A00ZA)
PART ONE
Add-A-Fuse attach to Fuse Box
Grounding Bolt behind
How to get behind Glove Box
- Open Glove box and empty your belongings
PART TWO
Let's start off by me showing you how to set up the button before all the wiring begins.
Make sure the Button is in this position or everything will go wrong
Pin 5- Positive, this completes the circuit for the on/off function
Pin 4- Power for switch
Pin 3- GROUND for Switch
Pin 2- Power/Live wire for illumination
Pin 1- GROUND for illumination
I had extra Pigtail pins from my Inspire Mirror Wiring so I used it for a clean install, but you can easily take the button apart to solder the wires directly to the pins.
Here is my final result, don't mind the button on the Blank Cover, that is my "Booty Call". (The red things you see is tape, the Blank Cover is loose so I added tape to tighten it up.
*** You can run the wire behind the center console through this opening