v6 UR stock diameter lightweight pulley install question Engine and performance mods to make your Accord more racekar.

[lebanesebeast]

I will be using an air wrench to get the stock one off but when installing the UR pulley how exactly should i go about tightening it and to what degree? And if a torque wrench is required how much should i torque it too

[@ccord10]

it technically should be torqued to spec but since it hard to hold the crank without special tools you can use an air gun if your careful. i usually give them 2 quick trigger (1/2 second) pulls to tighten them after the bolt is snugged up.

[lebanesebeast]

it technically should be torqued to spec but since it hard to hold the crank without special tools you can use an air gun if your careful. i usually give them 2 quick trigger (1/2 second) pulls to tighten them after the bolt is snugged up.

Got it, btw what is the amount it should be torqued to? Thanks

[@ccord10]

torque for the crank pulley is 47ft/lbs.

[lebanesebeast]

torque for the crank pulley is 47ft/lbs.

Alright cool, thanks!!