Our8thGens

Hi

Im planning on ordering some work d9r wheels and a TEIN street advance coilovers

http://www.work-wheels.co.jp/products/w ... tem_id=166

for my daily 2010 accord coupe and want to check with you experienced guys if Im on the right track

specs:

F: 19x9.5 +38 245/40
R 10x10.5 +30 255/40 or 245/40 <-- not sure till now need help which is better ... the 245 seemed to have the same overall Circumference as the front but more poke than the 255 which seemed to have about 10mm nore Circumference than the fronts

so is it going to need work like a fender roll or pull front or rear since im going to lower it 1.5in intially and go lower step be step from there

and are these tire specs too stretched for a daily since is my main concern is that the lip doest hit the Raised pavement markers between the lanes since there are lots of them where I live

thanks,

wow ... its been 6 weeks with no replies ... lol

so, anyway I placed the order and the weels will take about 6 weeks to be manufactured

the coilovers are in stock but will be shipped 4 weeks late due to the fact that I ordered godspeed camber, toe and traction arms and these have an ETA of 3 weeks

.
.
.

I think I need to start a build thread ... hmm

Yes, start a build thread! I don't think your specs are super duper aggressive, so you should be able to get away with a fender roll. However, I'm a sedan owner so coupe guys would know best.

What kind of coilovers did you order?

I'm running very similar specs with just a fender roll. 20x9.5 +38 245/30/20 up front 20x10 +30 255/30/20 rears, lowered about 2.5" on BC coils. Sits nice and flush, you'll be fine

Yeah if im not mistaken it seems you coupe guys have a lot more room for an aggressive setup compared to a sedans. Im trying to run 19x10 et24 in the rear and dang is that pushing it

Sent from my LG-H811 using Tapatalk

well...

its been a while since I started this thread

I ended up not buying the wheels but got the tein street advance coilovers and the the jspeed 3 arm kit

shoud I start a build thread ... hmmm

Just start the build thread lol...